Partial Replacement of Cement by Fly Ash & Aggregate by Glass Pieses

K Umamaheswari, A Roopa, E Ayyappa Reddy .

Abstract


Concrete is the most important engineering material and the addition of some other materials may change the properties of concrete. Mineral additions which are also known as mineral admixtures have been used with cements for many years. In the present study, an attempt has been made to investigate the strength parameters of concrete made with partial replacement of cement with 10%, 20% and 30% of Class F fly ash and fine aggregate was replaced with 10%, 20% and 30% of crushed cullet glass aggregate. The main parameter investigated in this study is M30 grade concrete with partial replacement of cement by 10%, 20% and 30% of Class F fly ash and fine aggregate was replaced with 10%, 20% and 30% of crushed cullet glass aggregate. On experimental investigation, it was found from the compression test results Mix no.15 having 30% fly ash 20% glass aggregate replacement shows the highest compressive strength and Mix no.15 and Mix no.3 having 20% glass aggregate replacement gives the highest tensile strength.

Full Text:

PDF

References


Asoka Pappu, Mohini Saxena, and Shyan R. Asolekar, “Solid Waste Generation In India And Their Recycling Potential In Building Materials”, Regional Research Institute (CSIR) and IIT Bombay, India.

P Turgut and E.S. Yahlizade, “Research into Concrete Blocks with Waste Glass”, International Journal of Civil and Environmental Engineering 1:4 2009.

Carpenter, A. J. and Cramer, C.M, “Mitigation of ASR in pavement patch concrete that incorporates highly reactive fine aggregate”, Transportation Research Record 1668, Paper No. 99-1087,pp. 60-67,1999.

I. B. Topcu and M. Canbaz, “Properties of Concrete containing waste glass”, Cement and Concrete Research, vol. 34, pp. 267-274, Feb. 2004.

A S Rossomagina, D V Saulin, and I S Puzanov, “Prevention of Alkali-Silica Reaction in Glass Aggregate Concrete”, pp-2, Perm State Technical University, Russia.

V. Corinaldesi, G. Gnappi, G. Moriconi, and A. Montenero, “Reuse of ground waste glass as aggregate for mortars”, Waste Management, vol.2, pp.197-201, Jan.2005.

A. Shayan and A. Xu, “Value added utilization of waste glass in concrete”, Cement and Concrete Research, vol-34, pp.81-89, Jan.2004.

Abdullahi M (2012), Effect of aggregate type on compressive strength of concrete, International journal of civil & structural engineering, vol 2, no3, pp 791-800.

Papayianni , G. Tsohos, N. Oikonomou, P. Mavria, “Influence of superplasticizer type and mix designparameters on the performance of them in concrete mixtures”, Cement & Concrete Composite, Vol. 27, 2005, 217-222.

Krishna M.V., Rao P., Kumar Ratish and Khan Azhar M., A study on the influence of curing on the strength of a standard grade concrete mix, Architecture and CivilEngineering, 8(1), 23–34 (2010)


Refbacks

  • There are currently no refbacks.




© International Journals of Advanced Research in Computer Science and Software Engineering (IJARCSSE)| All Rights Reserved | Powered by Advance Academic Publisher.